The EP Greenhouse geared motor is a compact and lightweight reduction gear motor with a limit switch system that is suitable for assembly of a locally available electric electric motor. The geared motor can be used in manually-managed or climate-controlled ventilation and screen systems in greenhouses. The quick and easy-to-install EP reducer is usually rainproof and windproof. The gearbox includes a high protection course (IP65) and can be used in an ambient temperature of 0-60 °C.

The low-noise gear driver for Greenhouse includes a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel tranny means that the drive shaft is definitely locked when the decrease gearbox isn’t running. The fully sealed reduction reducer has an expansion chamber with a diaphragm to keep the gear essential oil at a low pressure under all situations, even at high temps. Thanks to the use of an growth chamber, the reducer could be installed in any position. There are no limitations, since there is no dependence on a bleed connect. The sealed reduction gearbox keeps the gear essential oil of the gear driver in ideal condition because of its entire operating life time. The geared motor is ideal for discontinuous use, working class s3-30%, with a maximum activation time of 25 minutes.

The Gear box reduction gearbox comes with an FT85 motor assembly flange, on to which a suitable IEC standard motor can simply be installed (EN 50347).

The Gear box includes a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit switch system is installed within an built-in chamber and is definitely enclosed by an impact-resistant plastic material cover. The limit change system is accessible and simple to adjust. The limit change system’s optimum switching range is usually 40 or 64 revolutions of the drive shaft. The cabling is linked in spring-clip connections. The gear reducer has an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.

The gear reducer for greenhouse includes 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates can be found as accessories.

Optimum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in case of software of 4-pole electric motor.
Protection class IP65.
May be used in ambient temperature ranges of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, optimum activation time 25 minutes.
Equipped as regular with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installation of IEC regular motor (EN 50347).
Maximum switching selection of limit switch program 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).