SMR Gearbox Installation
Satisfactory performance relies on correct installation. lubrication and maintenance. therefore it is crucial the instructions while in the set up and maintenance leaflet. provided with just about every gearbox. are followed meticulously. several of the essential aspects of belt and torque-arm installation are listed under.
1. Install pulley on gearbox input shaft as close on the reducer possible, and mount reducer on driven shaft as near to bearing as sensible. failure to perform this will likely induce excess loads while in the input shaft bearings and output bearings and could lead to their premature failure.
two. Install motor and wedge belt drive together with the belt pull at somewhere around 90° for the center line involving driven and input shafts. this will permit tensioning of your wedge belt drive with all the torque arm which need to preferably be in tension. if output hub runs anti-clockwise. torque arm ought to be positioned the proper.
3. lnstall torque-arm fulcrum on a rigid help so that the torque-arm might be at somewhere around ideal angles towards the center line through the driven shaft as well as the torque arm case bolt. ensure that there may be ample consider up within the turnbuckle for belt tension adjustment.
Hold close.
Bell drive might be positioned in any easy postion. if the torque arm is always to be used to tighten the belts, the drive need to be at about tight angle towards the line involving the input and output shafts.
Bell drive can be situated to your correct if desired.
If output hub rotates clock-wise. position belt drive and torque arm in opposite route to 
that shown inside the illustration.
Torque arm and belt take up.
Torque arm could possibly be mounted for the ideal if preferred.
