Having been more than twenty years in the industry , we continue steadily to improve our goods/quality and services among the market leaders today.
Carburizing process increases surface hardness and wear resistance, while the core remains tough and ductile.
Shot Peening to all or any Components
All Omega’s conveyor chain pieces are very well shot peened, so that you can increase component life.
Ultimate Material Specification
New materials specification with better strength in chain breaking load, yet is still the most cost-effective decision.
Professional Technical and Item Support
Supported by experienced group and recognized branches in strategic places throughout China
Transmission Sprocket Installation
1. Install the transmitting sprocket (with belt) on the key drive equipment. 2. Install the sprocket nut. The next procedure is based on whether a fresh or used nut is being installed. Note: The Transmission Sprocket nut has still left handed threads. Flip the nut counterclockwise to install on the key drive equipment. Sprocket Nut: apply red thread lock to the threads of the sprocket nut. As well smear a small level of crimson thread lock or clean engine oil on the inside facial area of the sprocket nut and the outside deal with of the sprocket. Limit the application form to where the surfaces of both parts contact each other. Install the sprocket nut until finger limited. 3. Obtain Final Drive Sprocket Locking Instrument (BAKER P/N: Tool-C) to lock transmitting sprocket. Proceed the following: A. Insert handle of software below pivot shaft inboard of bottom frame tube and put on sprocket. B. Snug thumbscrew to lock position of device on sprocket. 4. Obtain Mainshaft Locknut Wrench/Pilot (BAKER P/N: Tool-D). Proceed as follows: A. Install pilot on threaded end of mainshaft. B. Slide sleeve of locknut wrench over pilot and onto sprocket nut. C. Tighten sprocket nut to 60 ft-lbs. (81 Nm). As the nut is definitely tightened the take care of of the sprocket locking program rises to contact the pivot shaft, thereby avoiding sprocket/mainshaft rotation. 5. Scribe a straight brand on the transmitting sprocket nut continuing the collection over onto the transmitting sprocket. Tighten the transmission sprocket nut an additional 35 to 40 degrees. 6. Install lockplate over nut to ensure that the two diagonally reverse holes align with two tapped holes in sprocket. For the best in shape, lockplate could be rotated to several positions and will be put with either area facing sprocket. 7. If holes in lockplate usually do not align with those in sprocket, tighten sprocket nut as necessary (up to 45 degrees optimum) until sprocket and lockplate holes happen to be in alignment.
24 Tooth Sprocket Kit
Fits Big Twin 4 speed with rear disc